Transformer Services
Ensure transformers operate safely at peak performance. We service everything from small distribution units to large power transformers, with on-site and in-shop capabilities.
Transformer Testing
Turns ratio, insulation resistance, power factor, and DGA.
Oil Analysis & Testing
Sampling to detect contamination, moisture, and faults.
Thermal Imaging
IR thermography to identify hot spots and loose connections.
Transformer Maintenance
Scheduled preventive programs to extend equipment life.
Reconditioning
Oil replacement, bushing upgrades, and gasket replacement.
Failure Analysis
Forensic investigation to determine root causes.
Transformer Rentals Available: 1–10 MVA units for rapid nationwide deployment. Full delivery, placement, testing, and commissioning included.
Generator Rentals Available: from 50kW to 2000kW
Protective Relay Services
Expert testing, calibration, programming, and maintenance of protective relay systems for industrial, utility, and commercial applications.
Relay Testing & Calibration
Full-spectrum testing per NETA and manufacturer specs.
Coordination Studies
System-wide studies for selectivity and protection.
Digital Programming
Setting and configuring modern numerical relay systems.
Upgrades & Retrofits
Replacing obsolete relays with modern digital alternatives.
Repair & Warranty
In-house repair and warranty processing.
System Analysis
Performance analysis and protection gap identification.
Cable Testing Services
Hi-Pot Testing
DC and AC testing for cables up to 35 kV.
VLF Testing
Very Low Frequency medium-voltage assessment.
Partial Discharge
Sensitive PD testing for early degradation detection.
Power Factor Testing
Insulation deterioration detection in cable systems.
Cable Fault Location
Advanced TDR to pinpoint underground cable faults.
Acceptance Testing
New cable acceptance per NETA ATS specifications.
Upgrades & Retrofits
Switchgear Retrofits
Modernizing aging switchgear reusing existing structures.
Relay Modernization
Converting electromechanical systems to digital platforms.
Control System Upgrades
Updating control wiring, HMIs, and SCADA systems.
Motor Control Retrofits
Updating MCCs with modern drives and starters.
Breaker Retrofits
Replacing obsolete breakers with modern equivalents.
Arc Flash Reduction
Engineering solutions to reduce arc flash hazard levels.
Testing & Inspection
Switchgear Testing
Full NETA testing of LV, MV, and HV assemblies.
Circuit Breaker Testing
Contact resistance, timing, travel, and insulation.
Battery & UPS Systems
Load bank, impedance, and capacity verification.
Motor Testing
Surge, insulation resistance, and power quality.
Ground System Testing
Fall-of-potential and clamp-on grounding checks.
SF6 Gas Services
Gas handling, analysis, and refilling services.
Infrared Thermography
Certified IR inspections for panels and connections.
Power Quality Analysis
Harmonic analysis and voltage sag monitoring.
Engineering Studies
Arc Flash Studies
NFPA 70E and IEEE 1584 hazard analysis and labeling.
Short Circuit Studies
Fault current calculations for device ratings.
Coordination Studies
Time-current curve analysis for optimized protection.
Load Flow Analysis
Power flow studies identifying overloads and voltage issues.
System Harmonics
Harmonic distortion modeling and mitigation.
Maintenance & Contracts
Preventive Maintenance
Customized annual PM contracts for all critical infrastructure.
Acceptance Testing
New installation validation before energization.
Substation Contracts
Comprehensive agreements with defined response SLAs.
24/7 Emergency Service
Around-the-clock response for outages and failures.
Need a Custom Solution?
Contact our team to discuss your specific electrical testing and maintenance requirements.